- 弯曲模量 [MPa]: 12.0
Physical Properties | Metric | English | Comments | ||
---|---|---|---|---|---|
Specific Gravity | 1.62 g/cc | 1.62 g/cc | ISO 1183 | ||
Water Absorption | <= 0.10 % | <= 0.10 % | 23°C/24h | ||
Linear Mold Shrinkage | 0.0020 - 0.0050 cm/cm | 0.0020 - 0.0050 in/in | |||
Mechanical Properties | Metric | English | Comments | ||
Tensile Stress | 200 MPa | 29000 psi | |||
Elongation at Yield | 2.5 % | 2.5 % | |||
3.0 % | 3.0 % | flexural | |||
Modulus of Elasticity | 14.0 GPa | 2030 ksi | |||
Flexural Strength | 260 MPa | 37700 psi | |||
Flexural Modulus | 12.0 GPa | 1740 ksi | |||
Charpy Impact Unnotched | 3.00 J/cm² | 14.3 ft-lb/in² | flatwise; ISO 179 1fU | ||
2.50 J/cm² @Temperature -30.0 °C | 11.9 ft-lb/in² @Temperature -22.0 °F | ISO 179 | |||
Coefficient of Friction, Dynamic | 0.31 | 0.31 | |||
Coefficient of Friction, Static | 0.29 | 0.29 | |||
Electrical Properties | Metric | English | Comments | ||
Insulation Resistance | >= 1.00e+12 ohm | >= 1.00e+12 ohm | |||
Thermal Properties | Metric | English | Comments | ||
CTE, linear | 18.0 µm/m-°C | 10.0 µin/in-°F | DIN 53752 | ||
Thermal Conductivity | 0.420 W/m-K | 2.91 BTU-in/hr-ft²-°F | DIN 52612 | ||
Maximum Service Temperature, Air | 250 °C | 482 °F | |||
280 °C | 536 °F | short term | |||
Vicat Softening Point | 325 °C | 617 °F | DIN ISO 306 | ||
Flammability, UL94 | V-0 | V-0 | not recognized by UL | ||
Processing Properties | Metric | English | Comments | ||
Processing Temperature | 390 °C | 734 °F | mass temp | ||
Nozzle Temperature | 360 - 380 °C | 680 - 716 °F | |||
Zone 1 | 360 - 370 °C | 680 - 698 °F | |||
Zone 2 | 380 - 390 °C | 716 - 734 °F | |||
Zone 3 | 390 - 400 °C | 734 - 752 °F | |||
Mold Temperature | 170 - 200 °C | 338 - 392 °F | |||
Drying Temperature | 120 °C @Time 21600 - 28800 sec | 248 °F @Time 6.00 - 8.00 hour | or | ||
150 °C @Time 10800 - 21600 sec | 302 °F @Time 3.00 - 6.00 hour | Dehumidifying dryer | |||
Descriptive Properties | |||||
Color | natural color |