- 熔体流动速率 [g/10min]: 15.0
- 弯曲模量 [MPa]: 13.0
Physical Properties | Metric | English | Comments | ||
---|---|---|---|---|---|
Specific Gravity | 1.84 g/cc | 1.84 g/cc | ISO 1183 | ||
Water Absorption | <= 0.10 % | <= 0.10 % | 23°C/24h | ||
Linear Mold Shrinkage | 0.0040 - 0.0080 cm/cm | 0.0040 - 0.0080 in/in | |||
Melt Flow | 15 g/10 min @Load 5.00 kg, Temperature 380 °C | 15 g/10 min @Load 11.0 lb, Temperature 716 °F | |||
Mechanical Properties | Metric | English | Comments | ||
Tensile Stress | 90.0 MPa | 13100 psi | |||
Elongation at Yield | 1.0 % | 1.0 % | flexural | ||
1.5 % | 1.5 % | ||||
Modulus of Elasticity | 14.5 GPa | 2100 ksi | |||
Flexural Strength | 160 MPa | 23200 psi | |||
Flexural Modulus | 13.0 GPa | 1890 ksi | |||
Charpy Impact Unnotched | 2.10 J/cm² | 9.99 ft-lb/in² | edgewise; ISO 179 1eU | ||
Coefficient of Friction, Dynamic | 0.32 | 0.32 | |||
Coefficient of Friction, Static | 0.30 | 0.30 | |||
Electrical Properties | Metric | English | Comments | ||
Insulation Resistance | >= 1.00e+12 ohm | >= 1.00e+12 ohm | |||
Thermal Properties | Metric | English | Comments | ||
CTE, linear | 22.0 µm/m-°C | 12.2 µin/in-°F | DIN 53752 | ||
Thermal Conductivity | 0.500 W/m-K | 3.47 BTU-in/hr-ft²-°F | DIN 52612 | ||
Maximum Service Temperature, Air | 250 °C | 482 °F | |||
260 °C | 500 °F | short term | |||
Vicat Softening Point | 330 °C | 626 °F | DIN ISO 306 | ||
Flammability, UL94 | V-0 | V-0 | not recognized by UL | ||
Processing Properties | Metric | English | Comments | ||
Processing Temperature | 390 °C | 734 °F | mass temp | ||
Nozzle Temperature | 360 - 380 °C | 680 - 716 °F | |||
Zone 1 | 360 - 370 °C | 680 - 698 °F | |||
Zone 2 | 380 - 390 °C | 716 - 734 °F | |||
Zone 3 | 390 - 400 °C | 734 - 752 °F | |||
Mold Temperature | 170 - 200 °C | 338 - 392 °F | |||
Drying Temperature | 120 °C @Time 21600 - 28800 sec | 248 °F @Time 6.00 - 8.00 hour | or | ||
150 °C @Time 10800 - 21600 sec | 302 °F @Time 3.00 - 6.00 hour | Dehumidifying dryer | |||
Descriptive Properties | |||||
Color | natural color |