- 密度 [g/cm3]: 1.3
- 吸水率 [%]: 0.06
- 缺口冲击强度: 1.08
- 弯曲模量 [MPa]: 2.60
- 热变形温度 [℃]: 103.0
Physical Properties | Metric | English | Comments |
---|---|---|---|
Density | 1.30 g/cc | 0.0470 lb/in³ | ASTM D792 |
Water Absorption | 0.060 % | 0.060 % | ASTM D570 |
Linear Mold Shrinkage, Flow | 0.010 cm/cm | 0.010 in/in | MD |
Linear Mold Shrinkage, Transverse | 0.011 cm/cm | 0.011 in/in | |
Mechanical Properties | Metric | English | Comments |
Hardness, Rockwell M | 80 | 80 | ASTM D785 |
Tensile Strength at Break | 56.0 MPa | 8120 psi | ASTM D638 |
Elongation at Break | 100 % | 100 % | ASTM D638 |
Flexural Strength | 95.0 MPa | 13800 psi | ASTM D790 |
Flexural Modulus | 2.60 GPa | 377 ksi | ASTM D790 |
Izod Impact, Notched | 1.08 J/cm | 2.02 ft-lb/in | ASTM D256 |
Taber Abrasion, mg/1000 Cycles | 20 | 20 | CS-17; ASTM D1044 |
Electrical Properties | Metric | English | Comments |
Volume Resistivity | 1.00e+16 ohm-cm | 1.00e+16 ohm-cm | ASTM D257 |
Dielectric Strength | 25.0 kV/mm @Thickness 2.00 mm | 635 kV/in @Thickness 0.0787 in | ASTM D149 |
Arc Resistance | 125 sec | 125 sec | Tungsten electrode; ASTM D495 |
Comparative Tracking Index | 250 - 399 V | 250 - 399 V | IEC Pub1.112, class 2; IEC Method |
Thermal Properties | Metric | English | Comments |
CTE, linear | 70.0 µm/m-°C @Temperature 20.0 °C | 38.9 µin/in-°F @Temperature 68.0 °F | ASTM D696 |
Melting Point | 255 °C | 491 °F | By DSC |
Maximum Service Temperature, Air | 120 °C | 248 °F | Thermal index; ASTM UL746B |
225 °C | 437 °F | Ball pressure temperature; IEC Method | |
Deflection Temperature at 0.46 MPa (66 psi) | 103 °C | 217 °F | ASTM D648 |
Deflection Temperature at 1.8 MPa (264 psi) | 80.0 °C | 176 °F | ASTM D648 |
Flammability, UL94 | V-0 @Thickness 0.907 mm | V-0 @Thickness 0.0357 in | |
Processing Properties | Metric | English | Comments |
Melt Temperature | 255 - 265 °C | 491 - 509 °F | |
Mold Temperature | 90.0 - 120 °C | 194 - 248 °F |