- 熔体流动速率 [g/10min]: 3.3
- 弯曲模量 [MPa]: 3.00
Physical Properties | Metric | English | Comments | ||
---|---|---|---|---|---|
Specific Gravity | 1.10 g/cc | 1.10 g/cc | ISO 1183 | ||
Water Absorption | <= 0.10 % | <= 0.10 % | 23°C/24h | ||
Linear Mold Shrinkage | 0.0040 - 0.0080 cm/cm | 0.0040 - 0.0080 in/in | |||
Melt Flow | 3.3 g/10 min @Load 2.16 kg, Temperature 250 °C | 3.3 g/10 min @Load 4.76 lb, Temperature 482 °F | |||
Mechanical Properties | Metric | English | Comments | ||
Tensile Stress | 60.0 MPa | 8700 psi | |||
Elongation at Yield | 5.0 % | 5.0 % | |||
7.0 % | 7.0 % | flexural | |||
Modulus of Elasticity | 3.50 GPa | 508 ksi | |||
Flexural Strength | 90.0 MPa | 13100 psi | |||
Flexural Modulus | 3.00 GPa | 435 ksi | |||
Charpy Impact Unnotched | 7.00 J/cm² | 33.3 ft-lb/in² | flatwise; ISO 179 1fU | ||
Electrical Properties | Metric | English | Comments | ||
Surface Resistance | >= 1.00e+11 ohm | >= 1.00e+11 ohm | |||
Insulation Resistance | >= 1.00e+11 ohm | >= 1.00e+11 ohm | |||
Thermal Properties | Metric | English | Comments | ||
Maximum Service Temperature, Air | 90.0 °C | 194 °F | |||
140 °C | 284 °F | short term | |||
Processing Properties | Metric | English | Comments | ||
Processing Temperature | 250 °C | 482 °F | mass temp | ||
Nozzle Temperature | 250 - 260 °C | 482 - 500 °F | |||
Zone 1 | 230 - 250 °C | 446 - 482 °F | |||
Zone 2 | 240 - 260 °C | 464 - 500 °F | |||
Zone 3 | 250 - 270 °C | 482 - 518 °F | |||
Mold Temperature | 70.0 - 110 °C | 158 - 230 °F | |||
Drying Temperature | 75.0 °C @Time 21600 - 36000 sec | 167 °F @Time 6.00 - 10.0 hour | Dehumidifying dryer | ||
105 °C @Time <=14400 sec | 221 °F @Time <=4.00 hour | or | |||
Descriptive Properties | |||||
Color | dark grey |